This is a very musical speaker, with a lot of complex overtones.

click to enlarge

FluxTone Model 3

50 Watts rms, 8 or 16 Ohms, 12 inch, 15 pounds Much has been written about this Famous cone and voice. I do not think I can add much to that litany of praise, other than to say it is a very "Hearty Speaker" with a lot of class.

Demonstration

Microphone Beyer M 160 @ 18 inches (on axis)
Pre-Amp Grace Design M 501
Guitar Mexican Strat (Dimed)
Hear it 'Clean'

Flash required

Hear it 'Dirty'

Flash required

Left Channel = Crown D-75 (Everything set Flat)
Right Channel = Tweed DeLuxe (Volume-3, Tone-12)

Left Channel = Black face DeLuxe Reverb Volume 10, Treble 5, Bass 5
Right Channel = AC-30 top boost Volume 8, Treble 5, Bass 5

Includes VMT "Speaker Control" and Wires

click to enlarge

$1275 (list) + $50 Shipping in lower 48 states.

(If you're outside of this area, please Contact Us before ordering.)

Qty:

Technical Information

Celestion model (Vintage30) 60 watt 8 Ohm
This is the voice of an original Celestion Vintage 30. These images are relative.

FluxTone Model 3 50 watt 8 Ohm
This is the voice of a FluxTone Model 3. As you can see the pattern is nearly the same.

Note

Frequencies from a guitar speaker below 60hz are influenced more by the cabinet structure than the speaker, and frequencies above 6khz too high for any 12 inch cone to reproduce in a way that can be heard over the normal sounds coming from that speaker (that's why there are tweeters). That being factual, we say "ignore" the data on the graphs below 60hz and above 6khz because they have no bearing on this test.

General Specifications

Magnet Type (Alnico Topology) Copper & Iron
Magnet weight 11.5 Lbs.
Frequency Range 70-5000Hz
DC Resistance (Re) 7.3 & 12.9
Sensitivity 100dB
Chassis Type Pressed steel
Voice coil diameter 1.75", 44.5mm
Voice coil material Round copper
Resonance frequency (fs) 75Hz

© 2014 FluxTone, Inc.