FluxTone Model 2
"Original Jensen F-12-N"
Cone, spider, and voice coil C-12-N Jensen factory parts
This is speaker has a marvelous flat like response...think "JBL D-120"
FluxTone Model 2
50 Watts rms, 8 Ohms, 12 inch, 15 pounds, This driver has a smooth, straightforward and full-bodied tone with high frequency chime.
| Demonstration | |
|---|---|
| Microphone | Beyer M 160 @ 18 inches (on axis) |
| Pre-Amp | Grace Design M 501 |
| Guitar | Mexican Strat (Dimed) |
Clean - Crown D-75 (Everything set Flat)
Clean - Tweed DeLuxe (Volume-3, Tone-12)
Dirty - AC-30 top boost Volume 8, Treble 5, Bass 5
Dirty - Black face DeLuxe Reverb Volume 10, Treble 5, Bass 5
Includes VMT “Speaker Control” and Wires
$1500 (list) + $ Shipping in lower 48 states.
(If you're outside of this area, please Contact Us before ordering.)
Technical Information
Jensen model (P12R) 25 watt 8 Ohm
This is the voice of an original Jensen P12R, from a well preserved 50 year old driver.
FluxTone Model 2 50 watt 8 Ohm
This is the voice of a FluxTone Model 2. As you can see the pattern is nearly the same.
| Thiele & Small Parameters | |
|---|---|
| Magnet Type (Alnico Topology) | Copper & Iron |
| Magnet weight | 11.7 Lbs. |
| Resonant Frequency(fs) | 112Hz |
| DC Resistance (Re) | 6.5 |
| Coil Inductance (Le) | 0.90mH |
| Mechanical Q (Qms) | 7.01 |
| Force Factor (BxL) | 12.11 Wb/m |
| Total Q (Qts) | 0.92 |
| Compliance Equivalent Volume (Vas) | 27.6 liters |
| Mechanical Compliance (Cms) | 82 µm/N |
| Diaphragm Area (Sd) | 490.8 cm² |
| Reference Efficiency (no) | 3.48% |
| Maximum Linear Excursion (Xmax) | 1.0mm |
| Losses Electrical Resistance (Res) | 42.5 ohms |