FluxTone Model 3
"V-30"
Factory Original "Celestion Vintage 30" cone, spider and voice coil
This is a very musical speaker, with a lot of complex overtones.
FluxTone Model 3
50 Watts rms, 8 or 16 Ohms, 12 inch, 15 pounds Much has been written about this Famous cone and voice. I do not think I can add much to that litany of praise, other than to say it is a very "Hearty Speaker" with a lot of class.
| Demonstration | |
|---|---|
| Microphone | Beyer M 160 @ 18 inches (on axis) |
| Pre-Amp | Grace Design M 501 |
| Guitar | Mexican Strat (Dimed) |
Clean - Crown D-75 (Everything set Flat)
Clean - Tweed DeLuxe (Volume-3, Tone-12)
Dirty - AC-30 top boost Volume 8, Treble 5, Bass 5
Dirty - Black face DeLuxe Reverb Volume 10, Treble 5, Bass 5
Includes VMT “Speaker Control” and Wires
$1500 (list) + $ Shipping in lower 48 states.
(If you're outside of this area, please Contact Us before ordering.)
Technical Information
Celestion model (Vintage30) 60 watt 8 Ohm
This is the voice of an original Celestion Vintage 30. These images are relative.
FluxTone Model 3 50 watt 8 Ohm
This is the voice of a FluxTone Model 3. As you can see the pattern is nearly the same.
NOTE
Frequencies from a guitar speaker below 60hz are influenced more by the cabinet structure than the speaker, and frequencies above 6khz too high for any 12 inch cone to reproduce in a way that can be heard over the normal sounds coming from that speaker (that's why there are tweeters). That being factual, we say "ignore" the data on the graphs below 60hz and above 6khz because they have no bearing on this test.| General Specifications | |
|---|---|
| Magnet Type (Alnico Topology) | Copper & Iron |
| Magnet weight | 11.5 Lbs. |
| Frequency Range | 70-5000Hz |
| DC Resistance (Re) | 7.3 & 12.9 |
| Sensitivity | 100dB |
| Chassis Type | Pressed steel |
| Voice coil diameter | 1.75", 44.5mm |
| Voice coil material | Round copper |
| Resonance frequency (fs) | 75Hz |